![]() No need to remove any capacitors from the board.Compatible with BLTouch versions from 1.0 up to 3.x BLTouch original/generic versions enabled by default.The maximum amount of Marlin features that I was able to fit in the small 128KB memory.Official "vanilla "Marlin firmware with all hardware settings from Creality latest official firmware.It was downloaded and installed more than 10000 times and I believe most of the users will find no problems with it. Anyway, if you want to try this you can be sure I did the best I could to configure it properly and fit the maximum amount of features possible. Marlin 2.x is aimed to a new generation of boards using 32-bit processors, the built in libraries are bigger and there is less space left for features. The most stable and feature rich version of the firmware for this architecture is the 1.1.9 that I made available in another article. Please note that this is not the version I recommend for 8-bit boards like the one used in the Ender 3. The standard configuration file from Marlin distribution was carefully reviewed to include the latest Ender 3 specific settings from the official Creality firmware and from Antclabs. ![]() This is the vanilla version of Marlin Firmware 2.x pre-configured for Creality Ender 3 printers with original or generic BL Touch sensors.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |